Page Comparison

Below we have discussed are the properties and associated settings to configure for configuring an email notification channel. An email channel is always an permanently active channel.

Fig 3: Configuring Email Notification Channel

...

SMTP Server
This property is to set Server specifies the server's IP address or domain name (as an IP address or URL) that should be used to mail the for sending alert notifications.

Default: 127.0.0.1

...

SMTP Server Authentication Mode
To secure the exchange of emails, Intellicus Kyvos Reporting supports TLS authentication that is both to secure email exchanges, which can be either credential-based or certificate-based. Select either DEFAULT or STARTTLS as the value of for this property.

Default: (Default)DEFAULT

Example: SMTP_SERVER_AUTH_MODE=STARTTLS

SMTP Authentication
Set this property to to Enable if if the server used to send mails from Intellicus needs SMTP server requires user authentication to send the mailemails.   Set it to Disable if it doesn’tto Disable if authentication is not needed.

Default: Disable

Example: SMTP_AUTHENTICATION=Disable

SMTP Server User

This Use this property is to set specify the User user ID for the SMTP Server.  User needs to set server. Enter a valid user ID if your SMTP server authenticates requires authentication before sending mailsemails.

Default: blank

Example: SMTP_SERVER_USER= blank

SMTP Server Password

This property is to set sets the password to be used for the SMTP Serverserver.

Default: blank

Example: ENCR_SMTP_SERVER_PASSWORD=blank

SMTP Server Certificate File Name

You may specify Specify the path where the TLS certificate is stored under SMTP Server Certificate File Name this property, along with credentials, if the SMTP Server Authentication Mode is set to “STARTTLS” STARTTLS. This certificate is used for verifying the identity at the time of to verify identity when sending emails.

Default: blank

Example: SMTP_SERVER_CERT_FILE_NAME=D://tlscert.cer

Secondary SMTP Server

Intellicus Kyvos Reporting supports a secondary SMTP server that could act acts as a backup in case if the primary SMTP server is unavailable or email delivery fails for some reason. This Use this property is to set Server to specify the server's IP address or domain name (as an IP address or URL) that should be used to mail the for sending alert notifications.

Default: blank

...

Secondary SMTP Server Authentication Mode

You need to specify Specify the secondary SMTP server authentication mode as either “DEFAULT” DEFAULT or “STARTTLS” STARTTLS.

Default: (Default)DEFAULT

Example: SECONDARY_SMTP_SERVER_AUTH_MODE=STARTTLS

Secondary SMTP Authentication

Set this property to to Enable if if the secondary server used to send mails from Intellicus needs requires user authentication to send the mailemails.   Set it to to Disable if if it doesn’tdoes not.

Default: Disable

Example: SECONDARY_SMTP_AUTHENTICATION=Disable

Secondary SMTP Server User

You may specify the user name Specify the username for the secondary server in case if Secondary SMTP Authentication is enabled.

Default: blank

...

Secondary SMTP Server Password

You may specify Specify the password for the secondary server in case if Secondary SMTP Authentication is enabled.

Default: blank

...

Secondary SMTP Server Certificate File Name

You may specify Specify the path where the TLS certificate is stored under Secondary SMTP Server Certificate File Name property this property, along with credentials, if the Secondary SMTP Server Authentication Mode is set to “STARTTLS” STARTTLS. This certificate is used for verifying the identity at the time of to verify identity when sending emails.

Default: blank

...

Once you enter the required values,  Test to see if your

• Click Test to verify if the channel is successfully configured.

...

• Click Save to save the configuration.

• Click Discard to reset and start fresh.

Once you save a channel, you can click the horizontal ellipsis button to  to Remove Channel, if needed.

...

...

...

...

...

...

...