Manual Steps for Load Balancer Entry
- Sarabjeet Kaur
Applies to: Kyvos Enterprise Kyvos Cloud (SaaS on AWS) Kyvos AWS Marketplace
Kyvos Azure Marketplace Kyvos GCP Marketplace Kyvos Single Node Installation (Kyvos SNI)
From Kyvos 2024.2 onwards, the Load Balancer entry for the Marketplace has been automated for AWS and Azure. However, for GCP Marketplace, you still need to perform manual steps for Load Balancer Entry.
If the automation fails to manage the load balancer entry for any reason, you need to perform the manual steps mentioned in this section.
Note
When the application is able to identify the Load Balancer details, the inputs will be auto-populated and non-editable. However, if the application is unable to identify Load Balancer details, you must add the details manually, which is a one-time activity.
For the GCP Marketplace, if a Load Balancer was not created during deployment, Kyvos Manager will prompt for Load Balancer details if one has already been configured manually, to facilitate further automation.
This section describes the Load Configuration manual steps for:
Kyvos Manager Service
Adding Kyvos Manager nodes entry
For cloud environments where Load Balancer is used, after adding the Kyvos Manager service, you need to add the entry of Kyvos Manager nodes in the:
Target group (AWS) of Load Balancer
Backend Targets (Azure) of Load Balancer
Instance Group (GCP) of Load Balancer
Removing Kyvos Manager nodes entry
For cloud environments where Load Balancer is used, after removing the Kyvos Manager service, you need to remove the entry of Kyvos Manager nodes in the :
Target group (AWS) of Load Balancer
Backend Targets (Azure) of Load Balancer
Instance Group (GCP) of Load Balancer
Kyvos Web Portal Service
Adding nodes entry
For cloud environments where Load Balancer is used, after adding the Kyvos Manager service, you need to add the entry of Kyvos Manager nodes in the:
Target group (AWS) of Load Balancer
Backend Targets (Azure) of Load Balancer
Instance Group (GCP) of Load Balancer
Removing nodes entry
For cloud environments where Load Balancer is used, after removing the Kyvos Manager service, you need to remove the entry of Kyvos Manager nodes in the :
Target group (AWS) of Load Balancer
Backend Targets (Azure) of Load Balancer
Instance Group (GCP) of Load Balancer
Kyvos Reporting Service
Adding nodes entry
For cloud environments where Load Balancer is used, after adding the Kyvos Reporting service, you need to perform the following two steps:
Creation of
Target group (AWS) of Load Balancer
Backend Targets (Azure) of Load Balancer
Instance Group (GCP) of Load Balancer
Configure Load Balancer for Listener
Removing nodes entry
For cloud environments where Load Balancer is used, after removing the Kyvos Manager service, you need to remove the entry of Kyvos Manager nodes in the :
Target group (AWS) of Load Balancer
Backend Targets (Azure) of Load Balancer
Instance Group (GCP) of Load Balancer
Copyright Kyvos, Inc. All rights reserved.